Members Aaron SS Posted May 12, 2009 Members Share Posted May 12, 2009 Timmy > Pig Mine > DLS I'm considering it... Link to comment Share on other sites More sharing options...
Members turnitto11 Posted May 12, 2009 Members Share Posted May 12, 2009 would. And you never replied to my PM Link to comment Share on other sites More sharing options...
Members Bobby D Posted May 12, 2009 Members Share Posted May 12, 2009 do it! Link to comment Share on other sites More sharing options...
Members Aaron SS Posted May 12, 2009 Author Members Share Posted May 12, 2009 would. And you never replied to my PM Doh, my bad. PM incoming. Link to comment Share on other sites More sharing options...
Members zygoat Posted May 12, 2009 Members Share Posted May 12, 2009 Using these with the snax FX? I agree that you'd need a good fuzz pedal. Pig Mine seems promising because Skreddy can't put out a bad pedal. Link to comment Share on other sites More sharing options...
Members Aaron SS Posted May 13, 2009 Author Members Share Posted May 13, 2009 Yes I will be using these with teh snax fx but I may also be buying a Fender Champ tonight for a little tube setup to mess with. The DLS will probably be a bit redundant with the axe fx though so that one would probably be the last part of this equation bought. Link to comment Share on other sites More sharing options...
Members Crxsh Posted May 13, 2009 Members Share Posted May 13, 2009 Might I recommend DLS > Timmy > Pig Mine instead? Link to comment Share on other sites More sharing options...
Members Aaron SS Posted May 13, 2009 Author Members Share Posted May 13, 2009 Might I recommend DLS > Timmy > Pig Mine instead? No Link to comment Share on other sites More sharing options...
Members Crxsh Posted May 13, 2009 Members Share Posted May 13, 2009 Shame. IMO, Timmy before Skreddy Muff but after DLS is much WIN. Link to comment Share on other sites More sharing options...
Members Aaron SS Posted May 13, 2009 Author Members Share Posted May 13, 2009 Most likely they'd be used independently (though it's hard to say as no one knows really anything about the PM) but if I stacked them I'd go Timmy > PM or DLS. The DLS and PM probably wouldn't need to be stacked and I typically try to run low>high gain as far as my signal chain goes. Link to comment Share on other sites More sharing options...
Members Crxsh Posted May 13, 2009 Members Share Posted May 13, 2009 Like I said... IMO. Timmy > Ernie is fantastic. I set the gain around 10/11:00 on both and the Timmy really pulls the overdriven quality that I love so much about the Ernie out more. A touch of delay and you're absolutely golden for leads. And thus far I'm really enjoying the Timmy as a boost for the DLS. Renning it after helps tweak the tone a bit too... before is great too, but I'm quite pleased by the after results. Link to comment Share on other sites More sharing options...
Members sideshowlinc Posted May 13, 2009 Members Share Posted May 13, 2009 very expensive dirt section you got there but why not wait, thats probably just if you were here in australia... ergh, never mind Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.