Jump to content

Foot print


Recommended Posts

  • Members

I get 2 toms and 4 cymbals on one rack bar supported by the kick drum and one rack leg. All goes on a 3 x 6 desk mat with the front throne legs just on the back edge. Too much geometry for me. It's about 32 fl oz spilled.

Link to comment
Share on other sites

  • Members

My carpet is 5'x7' and I easily fit on there. Oddly, the only thing that goes off is normally my stool and I - like to sit a little bit back and am prone to, well, leaning back. Good for the abs, ya know?

Link to comment
Share on other sites

  • Members

My carpet is 5'x7' and I easily fit on there. Oddly, the only thing that goes off is normally my stool and I - like to sit a little bit back and am prone to, well, leaning back. Good for the abs, ya know?

 

Good for little naps as well...:p

Link to comment
Share on other sites

  • Members

Too big and increasing; working in the DTX-Multi 12 pad controller pretty regularly now, so the area just past the hats has expanded, and now I'm considering moving the 14" FT over to that side as well and running 1 FT on each side instead of both on the right.

Link to comment
Share on other sites

  • Members

I have my rug cut down to 6' x 6'-6" and fit everything on it, throne included. I could shave down the corners a little, but that allows me to "reserve" that much space so I can get in and out comfortably. If I have to set up in a corner, the back edges of the rug may go up the wall (or tuck under) a little.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...