Members skibob Posted May 12, 2009 Members Share Posted May 12, 2009 Just a little pre-sale research... Can anyone tell me if the Voodoo Lab Pedal Power 2 Plus will safely power a Shure PGX4 wireless receiver? The power reqs for the PGX says 12-18Vdc at 150 mA. It would also be running a couple of distortion pedals, like a TS9 and an OCD. Thanks... Link to comment Share on other sites More sharing options...
Members Yek Posted May 12, 2009 Members Share Posted May 12, 2009 The Voodoo Lab site now has an user forum. The man himself answers all questions.... Link to comment Share on other sites More sharing options...
Members skibob Posted May 12, 2009 Author Members Share Posted May 12, 2009 The Voodoo Lab site now has an user forum. The man himself answers all questions.... Didn't see that. I'll try there too. Link to comment Share on other sites More sharing options...
Members skibob Posted May 13, 2009 Author Members Share Posted May 13, 2009 In case anyone else is wondering, here is Voodoo Lab's response... This should be okay from outputs 5 or 6 with the DIP switch set away from normal. **NOTE: Check the polarity on the power supply, this may be center positive! You need to verify this and then use a reverse polarity cable. Because all Pedal Power 2+ outputs are isolated, you can power devices that require either polarity by using the correct cable. Please post your results, thanks! Regards,Josh FidenFounder / CEO Link to comment Share on other sites More sharing options...
Members NyteOwl Posted May 13, 2009 Members Share Posted May 13, 2009 FWIW, Visual Sound makes a 1-Spot 12-volt power supply that's designed specifically for wireless units. It will power up to five receivers... Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.