how do i fix this wiring job (out of phase)

[bassdudeguy]

it is a standard p/j setup with volume/volume/tone but the pickups are out of phase:confused:

 

how do i fix this

[phaeton]

1) Lift the pickguard or control cavity cover.

 

2) Desolder one of the pickup's two wires (I don't think it matters which pickup as long as you end up with them both going the same direction. However, if you can scare up a wiring diagram, it could tell you how it's supposed to be and you can tell which one is 'wrong'. It would be best to do it the 'right way' for pedantic reasons.)

 

3) Resolder the two wires, but switch places.

 

4) Reinstall the pickguard or control cavity cover.

 

5) Send me beer.

 

6) Lots. But quality over quantity.

[Kindness]

 

1) Lift the pickguard or control cavity cover. 2) Desolder one of the pickup's two wires (I don't think it matters which pickup as long as you end up with them both going the right direction. However, if you can scare up a wiring diagram, it could tell you how it's supposed to be and you can tell which one is 'wrong'. It would be best to do it the 'right way' for pedantic reasons.) 3) Resolder the two wires, but switch places. 4) Reinstall the pickguard or control cavity cover. 5) Send me beer. 6) Lots. But quality over quantity.

 

 

Check.

 

For clarity, step 2 should be "desolder both wires from one of the pickups..."