Members flaming turd Posted September 14, 2007 Members Share Posted September 14, 2007 ok, i'm putting a duncan custom into a prs. it has one volume pot, one tone pot, one p/up selector switch, and one output jack. the tone pot is also a push/pull switch. the duncan has bare, red, white, green, and black wires. which do i solder where? thanks. Link to comment Share on other sites More sharing options...
Members Jopop Posted September 14, 2007 Members Share Posted September 14, 2007 n00b http://www.seymourduncan.com/support/wiring-diagrams/schematics.php?schematic=2h_1v_1t_3w_1pp Link to comment Share on other sites More sharing options...
Members flaming turd Posted September 14, 2007 Author Members Share Posted September 14, 2007 ok, i wired it like that, but it hums pretty bad when the volume is up. what did i probably screw up? Link to comment Share on other sites More sharing options...
Members Hýrukante Posted September 14, 2007 Members Share Posted September 14, 2007 make sure the green and bare wires are well insulated and not touching anything else and that the solder joint is clean Link to comment Share on other sites More sharing options...
Members flaming turd Posted September 14, 2007 Author Members Share Posted September 14, 2007 make sure the green and bare wires are well insulated and not touching anything else and that the solder joint is clean is it ok for them to touch each other? Link to comment Share on other sites More sharing options...
Members Hýrukante Posted September 14, 2007 Members Share Posted September 14, 2007 yup Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.