Members Alex Pareja Posted June 3, 2012 Members Share Posted June 3, 2012 My 2nd channel went out yet my 1st clean still works fine. I immediately figured a preamp tube so I swapped v1 and v2 but nothing. Long story short I swapped all the preamp tubes with good ones I had from my last amp. Still no gain channel just dead quiet. The clean works but that is it. Any ideas?Thanks Link to comment Share on other sites More sharing options...
Members newholland Posted June 3, 2012 Members Share Posted June 3, 2012 can you manually switch channels- or it it only with a footswitch? what i'm getting at is, the switch may not be fully engaging. Link to comment Share on other sites More sharing options...
Members Alex Pareja Posted June 3, 2012 Author Members Share Posted June 3, 2012 Yes I can switch manually and with footswitch and nothing happens. Link to comment Share on other sites More sharing options...
Members newholland Posted June 4, 2012 Members Share Posted June 4, 2012 hrm.. could be a bad relay if you swapped tubes. i'd check in with the egnaters or a tech. just noticed you're from garfield! crazy.. i lived there a few years. i went to lincoln elementary for 2 years as a kid Link to comment Share on other sites More sharing options...
Members Alex Pareja Posted June 4, 2012 Author Members Share Posted June 4, 2012 I have to call tomorrow cause this amp is practically new. Yes I've been in Garfield for awhile, it's ok but I'm trying to go out west were it is a bit more open. Nice thing is everything or anything I would need is close to me. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.