Members dougbeens Posted October 26, 2005 Members Share Posted October 26, 2005 I've heard that because of the amount (or formula?) of the polyurethane that Ibanez uses in their finishes, they are extremely difficult to strip.... Is there any merit to this? What will I need to properly strip down my cheapie GSR bass? Link to comment Share on other sites More sharing options...
Members k4df4l Posted October 26, 2005 Members Share Posted October 26, 2005 depends on what method you go....mechanical by means of sand paper, heat and scraper or chemical Link to comment Share on other sites More sharing options...
Members knotty Posted October 26, 2005 Members Share Posted October 26, 2005 a pine stripper will have it off in no time! Link to comment Share on other sites More sharing options...
Members MONGOOZ Posted October 26, 2005 Members Share Posted October 26, 2005 i'm not sure...but maybe "homer formby's"..... but if the neck is a bolt on....remove it first.... and don't get formby's anywhere near the fret board....it will un-glue it!! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.