Members Hlbly1969 Posted June 1, 2009 Members Share Posted June 1, 2009 I am trying to program in Fades using Colorstrips. I am using Lightfactory software. When I set the Dimmer control channel to the appropriate dimmer channel in order to perform fades the only thing I get is a flash. For instanceChannel 1 is set DMX value of 210 through 219 to set the fixture in color fade mode Channels 2 through 4 are then used to fade red green blue respectively So I set the channel 3 to the appropriate level in the software and try and use the softwares fade in and out function. However the only thing I get is a flash of the color. What I assume is happening is that Lightfactory is trying to fade channel 1 and not channel 2 through 3. My question is for others that are using software with this fixture is how did you get it to work if you have? Thanks Bill Link to comment Share on other sites More sharing options...
Members Manford Posted June 12, 2009 Members Share Posted June 12, 2009 Check the fixture DMX address, as well as the assignment in the software. I've noticed that if either is off by one digit, funky things begin to happen. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.