Members seadoogsx1996 Posted August 22, 2008 Members Share Posted August 22, 2008 Hello, I have JBL MRX515 & SRX718s. I current use crossover bi-amp.Here is current set up:Mixer > Crossover > high > power amp > MRX515. Mixer > Crossover > Low > power amp > SRX718s. Now, I want to run FULL Range only 1 amp. So the set up will be:Mixer > power amp > MRX515 + SRX718s How can I wire full range with these speaker ? Thanks Link to comment Share on other sites More sharing options...
Members samkokajko Posted August 22, 2008 Members Share Posted August 22, 2008 You shouldn't/can't run full range into your subwoofers like that. you need to keep it with the crossover like you have it. Link to comment Share on other sites More sharing options...
Members Steve Edwards Posted August 22, 2008 Members Share Posted August 22, 2008 Your current set-up is correct. I don't have as much problem running highs in the lows (other than sounding crappy), but running lows into the highs can do damage. Also any time you have dissimilar speakers doing the same frequencies it can be a problem. You might even think about a speaker management product like a DBX Drive Rack PA Link to comment Share on other sites More sharing options...
Members jwlussow Posted August 22, 2008 Members Share Posted August 22, 2008 You can run the crossover high into channel A of the amp to the MRXs and crossover low to channel B to the SRXs. That would work and eliminate an amp. Not sure what amp you are planning on using but this will work if your amp can handle ohm load of daisy chained speakers. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.