Members vangkm Posted December 8, 2012 Members Share Posted December 8, 2012 I'm at a gig right now, we played one short set and we're playing another in a few hours. The sound guy there had only 1 XLR out for my IEM receiver (Audio Technica M2) which has stereo inputs. We are only using the L side and I'm not hearing much...the signal is weak and at full volume on the bodypack/receiver it's got a lot more static and the mix gets marginally louder. The transmitter has a loop out for both channels too...would it work if I just send the loop out of L back into the R input? I'm assuming it'll be ok and it would be the same as two mono signals split? Not sure what problems this could present too. Link to comment Share on other sites More sharing options...
Members vangkm Posted December 8, 2012 Author Members Share Posted December 8, 2012 Oh and I would just test it out except it's an event with things going on and no time in between. Link to comment Share on other sites More sharing options...
Members agedhorse Posted December 8, 2012 Members Share Posted December 8, 2012 Configure for mono Link to comment Share on other sites More sharing options...
Members Art Flood Posted December 8, 2012 Members Share Posted December 8, 2012 Originally Posted by agedhorse Configure for mono Yep, pretty sure one of the dip switches on the receiver is for stereo/mono selection. Link to comment Share on other sites More sharing options...
Members vangkm Posted December 10, 2012 Author Members Share Posted December 10, 2012 Thanks I got it going and the sound was much better. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.