Members Mahuska Posted December 12, 2011 Members Share Posted December 12, 2011 I used to own a Micron but sadly had to sell it. Now I have a AkaiMiniak(bought on blow-out)Micron and Miniaks are almost identical except for re=packagingand perhaps something else I am missing. Can some of the Miniak's/Micron respond to cc's on certaind patameters?I know there is NRPN options but even that gets confusing. Let me point to some docmuments and an actually editorthat adds to my confusion. First off: looking at the back panel(rear view) of the HyperSynth Miniak GU onthe left there 12 source and 12 destinations)2 columns. When you click on thesource there are 12 of them and later on down the list there are cc1-cc119 as choices. On theright of course a list of many destinations. If I am not wrong it appears youcan use cc's for parameters in the Mod matrix. However When I Examine the Micron's NRPN's pdf it lists left to right theCategory then parameter,NRPN(x/y/x) then min./max values.Towards the latter The Microns PDF chard shows values either well below 0 andway above 127 on many of the category choices of assignments. What gives? The problem is myNovation Xio25's template editor(for using it's midi controller knobs, buttons,and x/y pad) choosing edit on a knob or button brings up control settings forusing cc's, NRPN's and RPN's. The thing is the values can only be setnumerically from 0-127, be it CC's or NRPN'sWill it be a nightmare to program My Xio via Template editor, or even my Yamaha KX49which also has a similar template editor. Does the Hypersynth editor at leastallow you to choose CC's as described above successfully on the Miniak?Please help or lead me in the right direction as I have the Zio and KX49keyboard midi controller keyboards I would mainly use these controllersin a oerformance sceanrio and use the Hypersynth editor for deeper editingPlease help or point me in the right direction Link to comment Share on other sites More sharing options...
Members mildbill Posted December 14, 2011 Members Share Posted December 14, 2011 ... When you click on thesource there are 12 of them and later on down the list there are cc1-cc119 as choices. On theright of course a list of many destinations. If I am not wrong it appears youcan use cc's for parameters in the Mod matrix... Yep. If you want to use CC's and keep things simple, use the mod matrix. Example: Source = CC 17. Destination = Filter Cutoff. Amount = 100. Set this up in the mod matrix. You can do this directly on the Micron/MiniAk, so probably with an editor too. Then set your external controller board to send CC 17. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.