Thank you for the reply. Push push, pull push they are both up or down. There are two middle lugs on the switch , 2 and 5. normally routed to 5 i was wanting to confirm that 2 was the right choice. Since there is a forum, its better if I just flash this once and not heat this stuff up by doing it 4 times if the answer is there of course. No solderless so that is out. Calling a greasebucket tone pot a greaser didn't seem that confusing but I am in my own head, so hey, sounding boards are good. Maybe unnecessary but I won't know until I hear it if it is possible but isn't wiring the switch in parallel with a 250k resistor (theoretically) while in single coil mode then running a treble bleed after that in series going to replicate the stock wiring? While a 500k may be fine as far as application goes if I can replicate the single coil sound ( while minor differences make no distinction) maybe it will to me or to a recording. If it is possible, I am bored, so I am sure it will happen. I just wonder what I will have to replace if I fry something. I just don't have any idea how to wire that. 😀