Members gardo Posted October 20, 2019 Author Members Share Posted October 20, 2019 On 10/3/2019 at 7:44 PM, Freeman Keller said: I kind of lost track of the threads that I did here so I redid the tele one at TDPRI https://www.tdpri.com/threads/a-chambered-tele-ish-sort-of-thing.884657/ I also did a pretty complete one on frets and setup when you get to that point https://www.tdpri.com/threads/basic-setup.952636/ If there is anything I can do to help just give a shout. I'll be watching Thank you Freeman . One of the best tips I got came from one of your threads, don’t remember which one. This was setting the saddles to the lowest position and laying a straight edge on the neck and aiming for the top of the saddle. I thought it would be too low but tried anyway. It came out great Link to comment Share on other sites More sharing options...
Members Freeman Keller Posted October 21, 2019 Members Share Posted October 21, 2019 That is a hold over from my acoustic work. The rule of thumb for neck angle is that you want the fret plane to just hit the top of the bridge, which is the lowest you could possibly make the saddle. Relief and first fret action will raise the strings off the fretboard by somewhere close 10 or 20 thousands. If you want an action of, say 60 to 100 thousands then you need to raise the saddles twice that, in other words 0.100 to 0.150 or so. That is well within the range of adjustment for any electric bridge as well as acoustics and gives you the ability to further lower it in the future if the geometry changes. Have been watching this off and on and enjoying the ride. Link to comment Share on other sites More sharing options...
Members gardo Posted October 24, 2019 Author Members Share Posted October 24, 2019 On 10/18/2019 at 3:58 PM, badpenguin said: Nice work. I dig it. But.... no tort....?😪 Ok, I had.a little time this afternoon so I knocked out a couple pickgaurds Link to comment Share on other sites More sharing options...
Members gardo Posted October 24, 2019 Author Members Share Posted October 24, 2019 Countersink the holes and dress the edges with a half round file and put it on for a test fit I need to do a little more contouring but took some pics while the light is good. The difference between black and tort is subtle but nice. And of course no one likes the red but I did it anyway The more I look at the red the more I like it Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.