Members DylanWilde Posted April 9, 2006 Members Share Posted April 9, 2006 Say I have a Crybaby 535Q I need to change a capacitor in. How do I go about removing the one soldered in there already and putting a new one in? Do I have to remove the circuit board? Or can I just pop off the back, heat up the one on there, remove and solder the new into place? Link to comment Share on other sites More sharing options...
Members GuyaGuy Posted April 9, 2006 Members Share Posted April 9, 2006 personally i just heat the solder on there an pull gently on the wire. not the best way of getting things done but it works. a desolder pump is recommended and prolly some heat sink clips. Link to comment Share on other sites More sharing options...
Members Pwn3d Posted April 10, 2006 Members Share Posted April 10, 2006 Originally posted by GuyaGuy personally i just heat the solder on there an pull gently on the wire. not the best way of getting things done but it works.a desolder pump is recommended and prolly some heat sink clips. nah, if you just want to do it easy and simple without messing anything up just get some more solder, a de-soldering braid and your soldering iron. Link to comment Share on other sites More sharing options...
Members Pwn3d Posted April 10, 2006 Members Share Posted April 10, 2006 Originally posted by ZepFuzz05 Do I have to remove the circuit board? no Originally posted by ZepFuzz05 Or can I just pop off the back, heat up the one on there, remove and solder the new into place? yes Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.