Let's see your LS-2 selector set-up's....

[kylef]

in the middle of re-working my board, total clear out and changing all the options.

 

thing is i want to use my LS-2 for bringing in loads effects together, but am a total novice when it comes to it, and figuring it out. then i wondered how you guys ran yours?

 

so basically, how do YOU run your LS-2?

 

thanks

[Fender&EHX4ever]

At the moment it's only being used as a power source for a daisy chain ; but it's a fantastic pedal with so many possibilities. When I have a chance to experiment with it, I'd like to combine it with the SMMH's stereo inputs/outputs for some labyrinthine... stuff.

[IvIark]

It's not in use at the moment but in the past I've used it to convert a serial effect loop into parallel and also as a line mixer in my loop to put two processors in parallel with each other.

 

I've never used for its conventional use of bringing in different loops of effects but it's nice to know I've always got it so I can if I want to.

[K2000]

I've tried to use it as an A/B effects loop selector, and it made one of my main fuzzes sound like crap.

 

It's on the shelf until I can figure out a solution that doesn't involve using Boss pedals exclusively.

[IvIark]

A lot of fuzzes sound crap with any buffer in front of them, and something like the Fuzz Face would be a definite no no.

[sense_of_henry]

An older picture from when I was doing a little more recording, but I basically used it to go stereo. A good buffer at the end of the chain.