Members Eye_Of_The_Liger Posted April 2, 2010 Members Share Posted April 2, 2010 So the reverb tank in my combo amp tends to rattle pretty badly whenever I hit certain notes. I figure I can just take it out, tighten up whatever's loose, re-install it, TA-DAAAAA! But one day I happened to tighten the screws that attach the tank to the bottom of the amp, thinking that that might fix the rattling. It didn't, and I don't know if it's just me, but I think the decay time on the reverb got a little shorter as a result, so.... Before I take the reverb tank out, is there anything I should know first in regards to installation and/or maintenance? Link to comment Share on other sites More sharing options...
Members Eye_Of_The_Liger Posted April 2, 2010 Author Members Share Posted April 2, 2010 Link to comment Share on other sites More sharing options...
Members Jack Tone Posted April 2, 2010 Members Share Posted April 2, 2010 I would try doing just the opposite. I would loosen the screws, but put some rubber or felt grommets on both sides of the tank where the screws go to try and isolate the tank more. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.