ENGL Invader and G-Lab GSC-4, channel switching problem!!!

[Matija]

I just bought G-Lab GSC-4 and I have a question, my ENGL Invader 150 has 4 channels and I can't set it to switch channels with G-Lab. Have you any idea how I could set it up?

 

I I would be very grateful....

 

Thank you

[1001gear]

The manual says this:

 

5.2 Amp channel / function switching:

The diagram below indicates the layout connections of the SW1&2, SW3&4 and SW5&6 outputs.

SW1-6 OUTs are used for controlling the amp channels as well as other functions,

e.g. the amp’s built-in reverb.

G LAB consults with amp manufacturers in regards to their proprietary wiring of amp controlling/switching.

Information can be found in our website http://www.glab.com.pl which explains how to control a given amp

model and what cable or adapter is required. Many amps are equipped with a ¼’ female Jack( footswitch

input). If your amp is equipped with such type of connector, please check on http://www.glab.com.pl or ask

your dealer and amp manufacturer if it is possible to connect and control your amp directly (with mono

or stereo Jack/Jack or Y type cable) by using relay outputs.

Warning! DO NOT CONNECT THE SW1&2, SW 3&4 and SW5&6 OUTPUTS TO THE

EXTERNAL SWITCHING INPUTS OF THE MESA BOOGIE AMPS. To control these

types of amps use G LAB MIDI AMP CONTROLLER MAC-4.4 (product code 00876).

 

You amp is not listed on the site. It says there to contact them.