Members dermusolini Posted August 24, 2009 Members Share Posted August 24, 2009 i have the following ground control pro, gcx switcher.. 4 midi rack units/rackmounted pedals all goin into the switcher.. then a floorboard with 4 midi capable pedals i'd like at least two of these pedals to be midi controlled, but all the pedals only have midi in.. my midi chain goes from gcpro to switcher, in/thru/out of the rack gear, then ..... into midi in on a whammy iv... how do i then connect the remaining midi capable pedals? i need some kind of splitter plug i guess? Link to comment Share on other sites More sharing options...
Members Gorgon90 Posted August 24, 2009 Members Share Posted August 24, 2009 You need a midi splitter or midi thru box. The Phil Rees stuff is discontinued now apparently but the webpage below has some useful info about the concepts: http://www.philrees.co.uk/products/thruunit.htm Midi solutions aren't cheap but appear to have some similar bits of kit: http://www.midisolutions.com/products.htm Good luck with finding a solution. Link to comment Share on other sites More sharing options...
Members Yek Posted August 24, 2009 Members Share Posted August 24, 2009 MIDI Solutions Quadra Thru. This box splits an incoming MIDI signal into four MIDI Thru outputs and adds data corruption prevention. The LED is MIDI-powered (no battery or power supply required). Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.