Members senorblues Posted October 2, 2017 Members Share Posted October 2, 2017 It's always fine to start . . . after a while, you hear something slide, just slightly. Check it against an A440 source and it's clearly off. I'm mystified. Link to comment Share on other sites More sharing options...
Members 1001gear Posted October 2, 2017 Members Share Posted October 2, 2017 Strange. of course. There may be a short in one of your wheels, your analog emulation needs to be configured, stray LFO(s), do chips short? Link to comment Share on other sites More sharing options...
Members senorblues Posted October 2, 2017 Author Members Share Posted October 2, 2017 Last time, I noticed that the mod wheel had a slight effect, but didn't correct it. Working the pitch wheel, which I never touch otherwise, fixed it! Hopefully that's a failsafe solution. No to address prevention . . . . Link to comment Share on other sites More sharing options...
Members 1001gear Posted October 2, 2017 Members Share Posted October 2, 2017 Duck Tape in place. Link to comment Share on other sites More sharing options...
Members delaware dave Posted October 13, 2017 Members Share Posted October 13, 2017 My Kurzweil has functionality to disengage the mod wheel and pitch wheel. If the Yamaha has that same functionality I would disengage them one at a time and see which one causes the drift (probably the pitch wheel). If you don't use it then just disengage and problem solved. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.