Jealousblues

yeah, i was going to put the bird over on the right side, but when you sent me it I thought it looked better connected. So my guitar is nitro finished, if I were to seal this in...how would I go about doing it? I know in the instructions it tells me, but does any of that change for non poly finishes? does it even matter? its also not the end of the world if its not sealed

Well, just put mine on and took some pics (I changed the position I had in mind a little bit) I think it came out really nice good job by vidiot *the part where the G is "broken" up by the top, thats how my sketch was so it wasnt a flaw in the print or anything. it was good work. I thought it was cool you could do that from a scan I sent in

would these work right if you just put them on over the finish or is that what everyone is doing?