opelgt73

ABOUT ME: I am a 28 years old, been playing in live bands for 14 years now. I am a gear junkie and started into Live sound reinforcement when I was in college. Over the years I have continually upgraded my system to what you see below. I had to move temporarially for my job and don't have a band at the moment. In the mean time I have been upgrading my system. When I have a complete system again I will most likely do sound for some other bands. Board: Currently an A&H mix wiz. I would really like more channels but I can't decide on a board. I'm not inclined to go digital, but I don't know if I could give up having the board pre-wired like I do with the Mix Wiz. AMPS: Two Racks. FOH is 1 x Crown K2 for subs, 1 x Crown K1 for mids and 1 x Crown K1 for highs, two Meyer M1A's and two Meyer B-2's . Monitor Rack is 4 x QSC PLX1602 and 4 x Meyer M1's. I just recently purchased the last of these amps and am currently wiring the two racks. PROCESSING: Other than the Meyer processors I have a Klark Teknik DN7103 for FOH delay. I have a Klark Teknik SQ1G on FOH, and two SQ1G's for the monitors. A SQ1D for gates and comps. I also sometimes run an Alesis D4 for a triggered Kick. I am still in need of a good verb/chorus for the vox chanels. SPEAKERS: Mid/Hi cabs: 4 x Meyer UPA-1C's Subs: 2 x Meyer 650-R2's for larger gigs. 2 x Meyer USW's for smaller gigs. Monitors: 6 x Meyer UM1C's MICS: KSM9 - 1 SM87 - 2 SM57 - 3 SM58 - 2 Still need to get a good set of drum mic's Transport: 7x14 tandem axle box trailer. GMC full size 1 ton Diesel van. SUMMARY: I am currently wiring up the amp racks and acquiring additional gear. Next I will be turning to power distribution and lighting.