Members ghostpom12 Posted June 27, 2018 Members Share Posted June 27, 2018 Next we are ready to drill the holes for the posts. I was intrigued by a similar post I saw where the guy had a cheap “drill press”. Whereas I have a large press I bought this $19 “press” from harbor freight. Well… after I removed about 0.04” material from one of the adjustable arm flanges so it would slide freely top-to-bottom without binding, it was liveable but I would not recommend this route unless you didn’t know anyone with a press you could use. I mean, they’re kind of handy but they are really only a guide because they are so flimsy. I strongly recommend drilling these holes in a few stages i.e. start with a small – very small bit to ensure your hole is dead on. Then drill with a larger bit that will follow the other hole as a pilot. Work your way up to your desired size. This was ½”. Link to comment Share on other sites More sharing options...
Members Freeman Keller Posted June 27, 2018 Members Share Posted June 27, 2018 Hi Ghost. We seem to be missing PART I and II as well as any pictures or other information you intended to include with PART III Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.