Jump to content

Ibanez SD9 output?


palthegiraffe

Recommended Posts

  • Members

I enjoy using the Ibanez SD9 Sonic Distortion for non-fuzz distortion purposes, and like its sound. However, it sounds best on lower distortion levels (I like that knob at about 9 o'clock), and I then have to crank the volume knob all the way up just to get close to unity gain. Is there any component that can be changed just to boost the volume a little?

Link to comment
Share on other sites

  • Members

I have an Analogman modded SD-9 and I use the RGW Electronics "Bad Bob" pedal to give it that extra kick when I take a solo.

It's even great on it's own.

Put it at the end of your pedal chain for best results.

 

See it on my web site here! >>> Garyatrics >>> Our Stuff >>> Gary's

 

And here's Bad Bob's web site! >>> RGW Electronics Bad Bob booster pedal

 

Good Luck!

Gary B - Sweden

Link to comment
Share on other sites

  • Members

 

Originally posted by thebazaar

run it after the SD9. If you run it first, it will push a clean signal thru the pedal as well. Not a bad tone, but it may not be what you are after.

 

That's what I was afraid of. I suppose it's rearranging time! I've had the SHO first in the chain for a long time; but there's no particular reason why it couldn't be after the OD, fuzz, and SD9 but before the modulation.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...