If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
It's probably no harder then doing any other surface mounted stuffs. The switch, I believe, is only a momentary grain of rice, so any momentary switch will do, just replace the original one. The pots have their own board, so you either have to desolder them or drill the holes in the enclosure perfectly. Desolder the LED and jacks then put wires where they used to be. No harder then anything else.