Members juri Posted February 25, 2013 Members Share Posted February 25, 2013 Does someone know what drillbit is best for this? Does anyone know where you can buy a pedaltrain with the jacks already installed? Link to comment Share on other sites More sharing options...
Members Mr.Grumpy Posted February 25, 2013 Members Share Posted February 25, 2013 I would use a step drill bit, and drill the hole to size from each side. A twist drill will grab when the point breaks through, and can cause the drill to wrench out of your hands. Link to comment Share on other sites More sharing options...
Members juri Posted February 25, 2013 Author Members Share Posted February 25, 2013 $40 drill bit, dang Link to comment Share on other sites More sharing options...
Members TomCTC Posted February 26, 2013 Members Share Posted February 26, 2013 Those jacks are these: http://www.musiciansfriend.com/accessories/vtg-nj3fp6c-neutrik-trs-locking-connector with a little moulded plastic border added. I would route the Pedaltrain slats out and just drill the holes for the screws on the corners of the jacks. Link to comment Share on other sites More sharing options...
Members chrisjnyc Posted February 26, 2013 Members Share Posted February 26, 2013 Check the spam thread... there is one up now for $170 Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.