Harmony Central Forums
Announcement Announcement Module
Collapse
No announcement yet.

Drilling holes in pedaltrain for Neutrik jacks

Page Title Module
Move Remove Collapse









X
Conversation Detail Module
Collapse
  • Time
  • Show
Clear All
new posts

  • Drilling holes in pedaltrain for Neutrik jacks

    Does someone know what drillbit is best for this?  Does anyone know where you can buy a pedaltrain with the jacks already installed?

    DSC\_0013.JPG

    Attached Files

  • #2

    I would use a step drill bit, and drill the hole to size from each side. A twist drill will grab when the point breaks through, and can cause the drill to wrench out of your hands. 

    This space left intentionally blank.

    Comment


    • juri
      juri commented
      Editing a comment

      $40 drill bit, dang


  • #3
    Those jacks are these:

    http://www.musiciansfriend.com/accessories/vtg-nj3fp6c-neutrik-trs-locking-connector

    with a little moulded plastic border added. I would route the Pedaltrain slats out and just drill the holes for the screws on the corners of the jacks.
    Smooth deals with: duncan, the_bleeding, MrSandMan, 6StrngStrangler, mmmmmchina, gproud, Onehourlater, driverhasabomb, bluehuricane, melx, TheErosion, gschmittling, BrianPhase90, roaring20's, ibentmywookieFender Custom Shop '52 TelecasterGibson 2013 SG StandardFender Deville III 4x10Oh Henry! chocolate barsPedals n' stuffhttp://bearflagbearflagbearflag.bandcamp.com

    Comment


    • chrisjnyc
      chrisjnyc commented
      Editing a comment

      Check the spam thread... there is one up now for $170



Working...
X