Members BeëlzeM Posted September 24, 2010 Members Share Posted September 24, 2010 My 10 band MXR EQ started making a huge noise/hum sound with pops that just overrules the amp sound since yesterday. It's the first thing in the FX loop and then my Decimator comes right after it. But it can't filter the noise without touching the amp tone. It's not my FX loop as my Decimator works flawlessly without the EQ in there. It's terrible. Could it be the powersource or something, or a dirty jack. Or has anyone had this with a pedal and it turned out to be screwed inside? Link to comment Share on other sites More sharing options...
Members Cougar Hunter Posted September 24, 2010 Members Share Posted September 24, 2010 does it happen when the unit is turned off (in bypass mode)? Link to comment Share on other sites More sharing options...
Members BeëlzeM Posted September 24, 2010 Author Members Share Posted September 24, 2010 Yeah it does... Link to comment Share on other sites More sharing options...
Members Cougar Hunter Posted September 24, 2010 Members Share Posted September 24, 2010 Yeah it does... this is probably a good thing. could be bad switch, bad jack, IDK. Link to comment Share on other sites More sharing options...
Members timjtitus Posted September 24, 2010 Members Share Posted September 24, 2010 mine does this too, when it does it when it's off 2 of the middle sliders light up Link to comment Share on other sites More sharing options...
Members FastRedPonyCar Posted September 24, 2010 Members Share Posted September 24, 2010 one of mine did this but it was when I accidentally plugged in a speaker signal into it now it makes a loud farty sounding mess and the two outer led's flash all the time... I need to send it back but I'm lazy... and have another one. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.