Members bierball Posted December 21, 2012 Members Share Posted December 21, 2012 My Laney Cub12 only has one output for an extension speaker cabinet, and I have two Marshall JCM800 412. Would be nice to be able to play with both cabinets. Is this possible? Link to comment Share on other sites More sharing options...
Members diocide Posted December 21, 2012 Members Share Posted December 21, 2012 Yes if you daisy chain the speakers, but check your ohms to make sure your not running too small a load... Link to comment Share on other sites More sharing options...
Members tech21man Posted December 21, 2012 Members Share Posted December 21, 2012 Or, if the speaker out and laney internal speaker have the same load number (both 8 ohm or both 16 ohm which, 100% will be the case) and the JCM cabs have also the same ohmage, you can mod the speaker cable of the laney internal speaker to become a speaker out. It is dead easy. And connect one cabinet to the speaker out and the other to the modded cable. What ohmage does the speaker out state and what are the marshalls? And in that case you will give less than 2 watts in each speaker! Not so much to move all that air but it surely will get you loud and power amp distortion. Link to comment Share on other sites More sharing options...
Members newholland Posted December 21, 2012 Members Share Posted December 21, 2012 sure- you just need to daisy chain the cabs.http://www.colomar.com/Shavano/4x12wiring.html that way, your connector cables are 1) between the amp to the first cabinet, then 2) the first cabinet to the second. you do need to be mindful of impedance though-- with 2 16 ohm cabs, you'll have an 8 ohm load. if that's what your output's looking for-- you're set. Link to comment Share on other sites More sharing options...
Members Mike LX-R Posted December 21, 2012 Members Share Posted December 21, 2012 Originally Posted by bierball My Laney Cub12 only has one output for an extension speaker cabinet, and I have two Marshall JCM800 412. Would be nice to be able to play with both cabinets. Is this possible? please send us a pic of that tiny amp on top of a full stack Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.