If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I've been holding off on cab building mainly due to the lack of ability to construct finger joints with the tools I currently own. To see the Angle brace in the Mills...
Finger joints are all well and good but its pretty much just eye candy and if you're going to cover it then its a waste of time. Orange and matamp cabs are held together with dowelled butt joints and they hold up just fine. My preference is screw pocket joints. You can buy a kreg screw pocket jig for $20 and they are pretty damn good!
DCC Engineering. Custom Cabs and Effects.
Originally Posted by -Assy-
Okay I summed up this entire thread in three posts. Let's go home and beat our children.