If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
No announcement yet.
That thing that holds the strings, the nut?, moves and now my iteration is all ****************ed up.
Take a center punch...lightly tap it on one side...in case it just doesnt pop out since it is loose.
Use a sharp small chisel to flick off any glue in the slot...no gouges go easy...might be ok with an exacto knife. Flick excess glue from nut surface as well.
If there was no issues other than being loose ....fit it into the slot with the edges flush to the sides off the neck.
If all looks well use a couple of drops of wood working glue to cement it in place...dont use super glue because this is a part you want to easily tap back out when its time to replace it in the future.