Members caylor02 Posted May 8, 2008 Members Share Posted May 8, 2008 Ok guys.... I want to use a pedal in the serial loop of my JVM. If any of you are familiar with the JVM, the serial loop is at a line level, where as the parallel loop is switchable between -10 and +4. Is there a device I can put between the send of the serial loop and the input of the pedal I will be using to knock down the siganl to -10??? I hope that makes sense. Also will I have to bring the level back up to +4 at the output of the last pedal. I don't want to use theses pedals in the other loop. I hate parallel loops. Thanks guys. Adam Link to comment Share on other sites More sharing options...
Members sacredgroove Posted May 8, 2008 Members Share Posted May 8, 2008 This will do it. Automatically detects signal and converts it. Goes between FX send and pedal input. http://www.ebtechaudio.com/lls-2des.html Link to comment Share on other sites More sharing options...
Members caylor02 Posted May 8, 2008 Author Members Share Posted May 8, 2008 AWESOME!!! Thanks man. But will i have to bring the level back up at the output of the loop?? Thanks Link to comment Share on other sites More sharing options...
Members sacredgroove Posted May 8, 2008 Members Share Posted May 8, 2008 AWESOME!!!Thanks man. But will i have to bring the level back up at the output of the loop??Thanks Nope, the operating signal is converted for the Input of the pedal. Don't be fooled by the 2 loops on the Line Shifter, too. All you need is 1, the second can be used for another application. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.