Members rho Posted January 25, 2007 Members Share Posted January 25, 2007 Just picked up this unit to use thru my effects loop of my guitar amp. Since it is XLR only I was wondering if using 1/4 inch to XLR cables will cause any issues, I don't think so but have to ask. Here is a stock pick of the unit. If for some reason it will NOT work with a guitar amp, it will be for sale here if anyone is looking for one. Link to comment Share on other sites More sharing options...
Members agedhorse Posted January 25, 2007 Members Share Posted January 25, 2007 You will need to use XLR to TIP-SLEEVE cables, not TIP-RING-SLEEVE, and pin 1 will need to be jumpered to pin 3 on both XLR connectors. Link to comment Share on other sites More sharing options...
Members rho Posted January 25, 2007 Author Members Share Posted January 25, 2007 You will need to use XLR to TIP-SLEEVE cables, not TIP-RING-SLEEVE, and pin 1 will need to be jumpered to pin 3 on both XLR connectors. Thanks for the info, as you can see I'm not as familiar with XLR cables as I should be. Will this HZ cable work w/o any mods (it only has tip and sleeve), or will the guitar signal be affected in a negative way? Link to comment Share on other sites More sharing options...
Members rho Posted January 25, 2007 Author Members Share Posted January 25, 2007 I just read your reply again and it looks like this will work after I jumper pins 1 and 3 together. I hope that is correct Link to comment Share on other sites More sharing options...
CMS Author Craig Vecchione Posted January 25, 2007 CMS Author Share Posted January 25, 2007 I just read your reply again and it looks like this will work after I jumper pins 1 and 3 together. I hope that is correct Yup, that's the way. Good luck with it. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.