Members axeman25 Posted March 2, 2007 Members Share Posted March 2, 2007 I just got a hold of some peavey speakers that I'm going to use as monitors. I believe the inputs on them are bi-amp(able). I'm not sure if thats the correct term, but it has screws where you can run the speaker wires to highs or lows. Someone had cut off a female 1/4" connector (left about 6" of wire for someone to trip over) and wired it so the speakers will run full range off of the one input. What I want to know is: Can I use the exsiting crossover and get some jacks to permanetly wire them? How would I wire it so that I have two jacks (input and thru for daisey chaining)? Just wondering if anyone has done anything like this before or if I'm going to have to replace the crossovers. Thanks. Link to comment Share on other sites More sharing options...
Members agedhorse Posted March 3, 2007 Members Share Posted March 3, 2007 what model? Link to comment Share on other sites More sharing options...
Members dboomer Posted March 3, 2007 Members Share Posted March 3, 2007 parallel the two jacks to the input of the crossover. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.