Members shiplett77 Posted March 9, 2007 Members Share Posted March 9, 2007 This is my current PA set up for my band. We are running Two Peavey PV 115 Mains (400 watts rms, 8 ohms each) and Two Peavey PV 118 Subs (400 watts RMS, 8 ohms each) through a QSC RMX 2450 power amp. The mains run on Channel 1 (750 watts @ 4 ohms) and the subs run on Channel 2 (750 watts @ 4 ohms). Basically a mono set-up. We are running 1 vocal, 2 mic Link to comment Share on other sites More sharing options...
Members gadgetx23 Posted March 9, 2007 Members Share Posted March 9, 2007 Since you don't have separate mids and highs, you want to run 2-way stereo and just use the left side. The crossover point can vary, but start around 90-100 and adjust it to where it sounds best. Link to comment Share on other sites More sharing options...
Members shiplett77 Posted March 9, 2007 Author Members Share Posted March 9, 2007 I dont need to use channel 2 on the crossover at all? Link to comment Share on other sites More sharing options...
Members gadgetx23 Posted March 9, 2007 Members Share Posted March 9, 2007 If you're running mono, you only have subs and mains, and you're not bi-amping your mains; you want 2-way mono, which is accomplished by using one side of the 2-way stereo on your crossover. Link to comment Share on other sites More sharing options...
Members shiplett77 Posted March 9, 2007 Author Members Share Posted March 9, 2007 thanks bro! Link to comment Share on other sites More sharing options...
Members boomerweps Posted March 10, 2007 Members Share Posted March 10, 2007 Allow me to congratulate you on not falling into the dual 15 two way tops over subs deal. Prevents a LOT of confusion when starting out. Boomerweps Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.