Members lilgrasshopper Posted August 30, 2012 Members Share Posted August 30, 2012 There's a code UP when it turns on. I cannot get out of this state. Tried to reset several times but nothing. Any other tricks? Link to comment Share on other sites More sharing options...
Members agedhorse Posted August 30, 2012 Members Share Posted August 30, 2012 Did you try the full factory reset? IIRC, though, this may be a high memeory block failure OR it could be the result of a bad back-up battery at boot. Try the full factory reset first: http://www.tpa-az.com/downloads/MX200Manual_B.pdf Link to comment Share on other sites More sharing options...
Members lilgrasshopper Posted August 31, 2012 Author Members Share Posted August 31, 2012 Tried that but it doesn't respond..could I open the unit up and pull out ribbon cable and reconnect it? Will that reset it? Link to comment Share on other sites More sharing options...
Members scharris_99 Posted August 31, 2012 Members Share Posted August 31, 2012 Is it under warranty? Link to comment Share on other sites More sharing options...
Members agedhorse Posted August 31, 2012 Members Share Posted August 31, 2012 Tried that but it doesn't respond..could I open the unit up and pull out ribbon cable and reconnect it? Will that reset it? No. Perhaps a call to Harman (lexicon) support might yield some help? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.