Members Acid Hazard Posted January 20, 2009 Members Share Posted January 20, 2009 Great, so now my VFX-SD has started getting the "keyboard calibration error" message. Link to comment Share on other sites More sharing options...
Members carbon111 Posted January 20, 2009 Members Share Posted January 20, 2009 It's an easy fix. Bring it over, bro! Link to comment Share on other sites More sharing options...
Members Acid Hazard Posted January 21, 2009 Author Members Share Posted January 21, 2009 What times are you free? Link to comment Share on other sites More sharing options...
Members setAI Posted January 21, 2009 Members Share Posted January 21, 2009 welcome to the downside of being an ensoniq owner Link to comment Share on other sites More sharing options...
Members yee941(2) Posted January 21, 2009 Members Share Posted January 21, 2009 he is 70 for a t-bagand 40 an hour Link to comment Share on other sites More sharing options...
Members Acid Hazard Posted January 21, 2009 Author Members Share Posted January 21, 2009 he is 70 for a t-bagand 40 an hour I didn't ask for your mom's rates. Link to comment Share on other sites More sharing options...
Members WDMcM Posted January 21, 2009 Members Share Posted January 21, 2009 Not a big deal to solve. The contact circuit board under the keys is split into two sections; right and left. They are interconnected with a side mount multi-pin connector. This connector can become oxidized resulting in a poor connection and a failed calibration. The solution is to replace the connector with a short length of ribbon cable or individual wires that are soldered into the connector tracings on the left and right circuit boards creating a hard-wired connection. As I remember there are 10 pins, but I may be mistaking; it will be obvious once you take a look. Here is a possible momentary solution to the problem (this doesn't work all of the time, but I have had good luck with it in a pinch): With the power off, place you palm in the middle of the keyboard, grabbing a few keys above and below the central 'F' key and slowly press into the keybed. Release and do this again several times. What you are trying to do is clean the pins within the faulty connector by flexing the keybed. Let go of the keys, power up and cross your fingers. Good luck, Dave Link to comment Share on other sites More sharing options...
Members carbon111 Posted January 21, 2009 Members Share Posted January 21, 2009 It's relatively easy to solder new wires in - plus it's a permanent fix. I actually mention it at the end of my VFX webpage: http://www.carbon111.com/vfx.html Acid hazard lives relatively close so we'll get him fixed up. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.